XML Sitemaps Generator

Author Topic: sever loads and custom settings  (Read 8510 times)

chrishlife

  • Registered Customer
  • Approved member
  • *
  • Posts: 3
sever loads and custom settings
« on: March 24, 2011, 06:26:41 PM »
currently my first build (been running 10hours+) is using a lot of resources  load average: 8.42, 9.10, 9.85.  What i am worried about is that the sitemap has to re-build everything (crawl through everything again) to update.

Is there a setting where I can do an initial full crawl -> the rest of the scans are front page  + 2 levels (to see if there are any changes).

I currently run a huge wordpress blog and it has many posts/image galleries so re-crawling everything each time the sitemap is re-built is very hard.




XML-Sitemaps Support

  • Administrator
  • Hero Member
  • *****
  • Posts: 10625
Re: sever loads and custom settings
« Reply #1 on: March 25, 2011, 03:48:27 PM »
Hello,

yes, you can store existing full sitemap under a different filename (sitemapfull.xml for instance), then set Depth level to "2" in generator config, and all new sitemaps will be limited as a result.
Oleg Ignatiuk
www.xml-sitemaps.com
Send me a Private Message

For maximum exposure and traffic for your web site check out our additional SEO Services.

 

SMF 2.0.12 | SMF © 2014, Simple Machines
XHTML RSS WAP2