use Shell mode
« on: September 02, 2005, 02:43:59 PM »
Hello,

Thank you for your program, it is large.

I have a question.

I would like to use it in Shell mode. That is possible ?

Thank you for your answer.

Mick
Re: use Shell mode
« Reply #1 on: September 02, 2005, 08:01:32 PM »
Hi Mick,

thanks!

At the "Crawling" page you will find the command line under the "Cron job setup" block. You can use it in your shell to execute the generator crawler.
Re: use Shell mode
« Reply #2 on: September 02, 2005, 08:56:21 PM »
Hello,

Thank you for your answer.

In Cron mode,  the program uses the parameters recorded in the configuration ?

I think especially for the parameters recorded for :

Make a delay between requests, X seconds after each N requests (I am on a mutualized server…)

and

Ping Google when generation is done

I have another question.

It would be possible to build a page HTML ?

It would be formidable to be able to use your program to build a map of the site...

Thank you for your answer.

Mick
Re: use Shell mode
« Reply #3 on: September 05, 2005, 09:59:59 PM »
Hi Mick!

1. Yes, all parameters will be extracted from the config file, so it will act exactly the same as running from the browser.
2. The generation of html sitemap is not the purpose of this software (this may be the feature to include in the future version though ;) )